MD&M MN Week Nov 2-3, 2011

Posted by on November 1, 2011 | 0 comments

Just a reminder to attend the MD&M trade show that begin tomorrow at the Minneapolis Convention Center.   Premold Corp will be exhibiting there at booth #1118.

Do you have a project that you would like to discuss?  We can help you discern if the RIM process is a good fit for your project.  If this project is not a good fit, we may suggest another process better suited for your application.

Remember that RIM (reaction injection molding) is well suited for low volume parts, in small batches.

Leave a Comment